Ariens Sno-Thro 921001 - ST824E Manuel d'utilisateur télécharger pdf (Page 10)

GB - 10

2. Insert the barrel on the cable end into the bracket

on left side of chute deflector (Figure 12).

3. Hold seal out of the way while routing the cable

through the bracket on the left side of the

discharge chute, and then push the cable fitting

into the bracket.

4. Push the seal securely over the end of the cable

fitting to prevent water from entering the cable.

5. Check deflector travel. Adjust nut on cable end

under handlebar to obtain full travel, if necessary.

(see Deflector Remote (921002, 003, 004) on

page 22).

Check Function of Dual Handle Interlock

Without the engine running, press down (engage) both

clutch levers. Release attachment clutch lever.

Attachment clutch should remain engaged until traction

clutch lever is released, then both clutches must

disengage. If they do not, contact your Dealer for

repairs.

Check Tire Pressure

Check tire pressure and adjust to the pressure listed on

tire sidewall.

Check Auger Gearcase Oil

Check oil level in auger gearcase (see Check Auger

Gearcase on page 19).

Check Engine Crankcase Oil

IMPORTANT: The engine is shipped with 5W-30 oil in

crankcase. Refer to Engine Manual for detailed

instructions.

Fill Engine Fuel Tank

Refer to Engine Manual for proper fuel type and tank

capacity.

Check Function of all Controls

Ensure unit runs and performs properly. Refer to

OPERATION on page 13.

Run-in Attachment Belt

1. Start unit in a well-ventilated area according to

Starting and Shut Off on page 17.

2. Engage attachment clutch lever and run

attachment for about 15 minutes.

3. Stop unit, wait for all moving parts to stop, and

remove spark plug wire.

4. Adjust belt finger, if necessary. See Check Belt

Finger Clearance on page 26

5. Adjust clutch idler according to Attachment

Clutch/Brake Adjustment on page 24.

Figure 12

1.Cable Anchor

2.Cable End

3.Deflector Cable

4.Cable Fitting

5.Cable Bracket

OS7070

CAUTION: Avoid injury! Explosive separation

of tire and rim parts is possible when they are

serviced incorrectly:

• Do not attempt to mount a tire without

the proper equipment and experience to

perform the job.

• Do not inflate the tires above the

recommended pressure.

• Do not weld or heat a wheel and tire

assembly. Heat can cause an increase

in air pressure resulting in an explosion.

Welding can structurally weaken or

deform the wheel.

• Do not stand in front or over the tire

assembly when inflating. Use a clip-on

chuck and extension hose long enough

to allow you to stand to one side.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

Commentaires sur ces manuels

Pas de commentaire

Ariens Sno-Thro 921001 - ST824E Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ariens Sno-Thro 921001 - ST824E