Ariens 911094 - Pro 21SCH Manuel d'utilisateur télécharger pdf (Page 21)

GB - 21

IMPORTANT: NEVER spray unit with high-

pressure water or store unit outdoors. Store

mower in a cool, dry, protected location.

Cleaning

Clean unit thoroughly with mild soap and low

pressure water. Brush off dirt and debris from

all surfaces. Touch up all scratched surfaces

to prevent rust. Matching touch-up paint is

available from your Gravely Dealer. Do not

use abrasives, solvents, or harsh cleaners.

Inspection

Inspect mower and repair or replace worn or

damaged parts to avoid delays when

beginning use again.

Regularly check all hardware and keep

fasteners tight. Know unit is in safe working

condition.

Grass Bag

Wash out grass bag and allow to dry before

storage. Grass bag may be stored in position

on mower.

Engine

When storing unit for extended periods of

time, remove all fuel from tank and carburetor

(run dry). Refer to engine manual.

STORAGE

CAUTION: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

TROUBLESHOOTING

PROBLEM PROBABLE CAUSE CORRECTION

Engine will not

start

1. Fuel tank empty or low.

2. Spark plug wire loose or off.

3. Throttle control not in proper

position.

4. Engine/Blade control cable

detached, broken, or not

adjusted properly.

1. Check fuel level. Fill tank if

necessary.

2. Check connection.

3. Adjust throttle to FAST

position.

4. Check cable. Adjust, repair

or replace as necessary.

Engine is

difficult to

restart

1. Mower clogged with grass. 1. Clear clippings from under

mower. (Allow the mower to

clear clippings before

shutting off engine.)

Cut is poor

1. Worn blade.

2. Too much grass is being

removed per cutting.

3. Grass is too wet.

4. Mowing speed is too fast.

1. Check blade (see Check

Mower Blade on page 15).

2. Raise cutting height.

3. Allow grass to dry.

4. Mow slower.

Grass does

not disperse

evenly

1. Too much grass is being

removed per cutting.

2. Grass is too wet.

3. Mowing speed is too fast.

1. Raise cutting height.

2. Allow grass to dry.

3. Mow slower.

Mower does

not bag

clippings

1. Grass bag is overfilled.

2. Mulching plug is installed.

1. Empty grass bag and do not

allow it to overfill.

2. Remove mulching plug.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Commentaires sur ces manuels

Pas de commentaire