Ariens 911413-WAW 34 Spécifications télécharger pdf (Page 14)

GB - 14

Align the open ends of the spacers with the

flats on the caster spindle and remove the

spacers one at a time until enough are left at

the bottom for the desired cutting height.

Remove the lock pin while supporting the

caster arm. Lower the arm on top of the

remaining spacers. Put the spacers that were

removed in the caster spindle above the

support tube as shown (Figure 8).

Reinstall the lock pin into the top hole and flip

over the lock ring to secure the remaining

spacers and pin.

NOTE: Set both wheels at the same height

for a level cut.

Figure 7

Spacers

Lock Pin

Flats

Figure 8

Remove the

spacers from

the stack.

Secure spacers

above the

caster arm with

the lock pin.

NOTE: Axle positions are set at the

factory. There should be no need to

change the axle position in the caster

in normal use or maintenance.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Commentaires sur ces manuels

Pas de commentaire