Ariens 991074-Max Zoom 52 Spécifications télécharger pdf (Page 15)

GB - 15

Fuel Stabilizer

Gasoline left in the fuel system for extended

periods without a stabilizer will deteriorate,

resulting in gum deposits in the system.

These deposits can damage the carburetor

and the fuel hoses, filter and tank. Prevent

deposits from forming in the fuel system

during storage by adding a quality fuel

stabilizer to the fuel. Follow the

recommended mix ratio found on the fuel

stabilizer container.

PRE-START

1. Check Safety Interlock System

If this system does not function as described

do not operate until repairs are made.

2. Check Air Cleaner

Check air filter for dirt. Clean as required.

Follow Engine Manual Maintenance

Schedule.

3. Check Engine Fuel and Crankcase

Oil

Check and add fuel if required. Check that

engine crankcase oil is full. Follow Engine

Manual Maintenance Schedule.

4. Check Tire Pressure

See Specifications on page 31 for correct tire

pressure.

5. Check Hydraulic Fluid Level

See Check Hydraulic Fluid Level on page 19.

6. Adjust Seat

Be sure all controls can be reached safely

from operator’s position.

7. Set Cutting Height

Make sure the deck is set to the correct

cutting height.

STOPPING IN AN EMERGENCY

1. Return steering levers to neutral position

2. Immediately set parking brake

3. Turn off PTO and engine

STARTING AND SHUT OFF

To start the engine:

1. Make sure the steering levers are in

neutral.

2. Put the PTO switch in the “Off” position.

3. Engage parking brake.

4. If the engine is cold, move the choke

control to the “On” position. If the engine

is warm or hot, do not use choke.

5. Move the throttle to 3/4 “Fast” position.

See Engine Manual for detailed

instructions.

6. Put the ignition key in the switch and

turn it to the “Start” position.

7. As soon as the engine starts, release the

key.

8. Move the choke control to the “Off”

position from the “Choke” position. Wait

until the engine is running smoothly

before operation.

To stop the engine:

1. Bring the steering levers to neutral.

Disengage the PTO and engage the

parking brake.

2. Move the throttle lever to the “Slow”

position.

3. Turn the ignition key to the “Off” position.

TO MOW WITH UNIT

Operate the unit only when seated in the

operator’s position.

1. Start the engine. Let the engine warm

until it is running smoothly.

2. Release parking brake.

CAUTION: Make sure all

hardware is tight, all safety

devices are in place and all

adjustments are made correctly.

WARNING: Operating unit on

slopes may lead to loss of

steering control. When operating

on slopes be prepared to react to

an emergency situation.

CAUTION: Read entire

Owner/Operator Manual, Clutch

Manual, and Engine Manual first.

DO NOT attempt to start engine

at this time.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Commentaires sur ces manuels

Pas de commentaire