Ariens 991074-Max Zoom 52 Spécifications télécharger pdf (Page 16)

GB - 16

3. Bring the steering levers to neutral.

4. Slow the engine down to about 3/4

speed.

5. Turn ON the PTO switch to engage the

mower.

IMPORTANT: Never engage the PTO if the

mower is plugged with grass or other

material. This may cause damage to the

electric clutch.

6. Move throttle control to fast.

7. Move the steering levers forward to

obtain a slow ground speed.

8. To disengage the mower, move the PTO

switch to the “Off” position.

9. When you know how to operate the unit,

select a speed appropriate to your

mowing conditions.

PARKING

To park the unit:

1. Bring the steering levers to neutral. Turn

off PTO.

2. Move the throttle lever to the “Slow”

position.

3. Engage the parking brake.

4. Lower the attachment.

5. Turn the ignition key to the “Off” position

and remove the key.

MOVING THE UNIT WITH THE

ENGINE OFF

IMPORTANT: Never tow unit.

1. Shut OFF engine.

2. Place seat in the service position (See

Service Position on page 18).

3. Pull the right and left bypass levers to

the neutral position.

4. Disengage parking brake.

5. Push unit to desired location.

6. Engage parking brake.

7. Push the right and left bypass levers to

the drive position.

FOR BEST PERFORMANCE

Cut grass when it is dry.

Keep mower blades sharp.

Keep mower deck properly levelled.

Adjust anti-scalp rollers to prevent scalping.

Do not set height of cut too low. For very tall

grass, mow twice.

Do not travel too fast.

Mow with the engine set at full throttle.

When mulching, only remove 1/3 of grass

length per cutting. Do not cut more than

1 inch (2.54 cm) at any one time.

Discharge clippings into areas already cut.

Vary cutting pattern with each mowing.

Do not allow grass or debris to collect inside

of mower deck. Clean after each use.

WARNING: Move the steering

control levers slowly and keep the

throttle control lever at slow

speed until you learn how to

operate the unit.

WARNING: Do not bypass

transmission when on a slope.

OF4105

OF4110

Pull Lever Out to the Neutral Position

Figure 5

Push Lever In to Drive Position

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Commentaires sur ces manuels

Pas de commentaire